Verex MONITOR AFx Guide d'installation télécharger pdf (Page 8)

21-3691Erev1.3

HSC-IP Module Installation Instructions

9 / 2008

Guardall (formerly VEREX Technology)

5201 Explorer Drive, Mississauga, Ont., Canada. L4W-4H1

sales@verextech.com +1 905.206.8434 | support@verextech.com +1 905.206.8436 | Fax: +1 905.629.4970

www.guardall.com | +1 877.249.9993

• Upgrade HSC-IP module’s firmware version to a newer one.

• Force If the HSC-IP module’s firmware is being upgraded and a problem occurs, this button can be pushed to force the

upgrade.

• If the connection was unsuccessful, the “Abort” button will be enabled. Press it to re-enable the “Connect” button and try

again. Be sure the HSC-IP module is in Discovery mode (3 green lights flashing on/off together) or, repeat steps 2 – 5 if

they are not.

Connect Remotely to a

Configured HSC-IP Module

• The HSC-IP module’s firmware

version must be “413” or greater.

• Check the “Connect remotely to a

configured IP Module on a

LAN/WAN”.

• Enter the HSC-IP module’s IP

Address and Password if one

was assigned.

• Uncheck DHCP and enter the

HSC-IP module’s IP address, Net

Mask and Gateway under

“Network” in the “System” tab.

• Press the “Connect” button to

connect with the HSC-IP module.

Information

• Once the Utility connects with the intended HSC-IP module, this section will display details about any current

programming present in the HSC-IP module.

• The module’s MAC address, firmware number, program file name, protocol or identifying name (IP Address) will display.

System Section

Press the “System” button from the list on the left side of the Utility.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Verex MONITOR AFx Guide d'installation Page 8