Verex Monitor ISM Guide de l'utilisateur télécharger pdf (Page 6)

iv MONITOR ISM™ LCD Keypad User's Guide 21-0375v4.2

FCC Class A Digital Device Notice

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

This equipme

nt has been tested and found to

comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide

reasonable protection against harmful

interference when the equipment is operated

in a commerci

al environment. This equipment

generates, uses, and can radiate radio

frequency energy and, if not installed and used

in accordance with the instruction manual,

may cause harmful interference to radio

communications. Operation of this equipment

in a resi

dential area is likely to cause harmful

interference in which case the user will be

required to correct the interference at his own

expense.

Warning: Changes or Modifications not expressly

approved by CSG Security Inc. could void the user's

authority to operate the equipment.

Customer Instructions pertaining to

FCC Regulations

This equipment complies with Part 68 of the

FCC rules. On the casing of this equipment is

a label that contains, among other information,

the FC

C registration number and ringer

equivalence number (REN) for this equipment.

If requested, this information must be provided

to the telephone company.

This equipment is designed to be connected to

the telephone network or premises wiring

using a hard wir

ed connection that does NOT

rely on a modular jack. If a modular jack is

installed, it is the responsibility of the installing

company to ensure that the jack and/or plug

comply with FCC Part 68 requirements.

Applicable Jack USOC: RJ-

11 (Dependent

type of equipment, i.e. Standard modem,

Digital TE, Tie-Trunk)

The REN is used to determine the quantity of

devices which may be connected to the

telephone line. Excessive REN's on the

telephone line may result in the devices not

ringing in response to an

incoming call. In

most, but not all areas, the sum of REN's

should not exceed five (5.0). To be certain of

the number of devices that may be connected

to a line, as determined by the total REN's,

contact the local telephone company.

1 2 3 4 5 6 7 8 9 10 11 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

Verex Monitor ISM Guide de l'utilisateur Page 6

Commentaires sur ces manuels