Verex MONITOR AFx Guide de l'utilisateur télécharger pdf (Page 177)

500-9041 v4.1

Welcome Report Control Admin

Sys Config

Tech-Ref

171

Pick-List

(bottom of the form)

-Panel:

If the tree is

not

set to show

items on a panel-by-panel basis, you

will be able to select a panel here (for

systems that have more than one).

A "Panel Group" reference may also be

shown here,

you can set the 'tree' to list

configuration topics separately for each

panel. For more information, refer to "Other

Desktop Choices".

On This Form

- Panel

(firmware) and

File Versions:

Revision information for the panel

(which is read-in during each communication

attempt);

To allow panel communications, the panel version

must be set correctly through the "Account

Information" screen.

Account Information: See the section entitled

"Account-Wide Panel Settings" (previous).

Panel Communications: See the section entitled

"Panel Communications and Updates" (previous).

Note:

Some features may be supported

only

after

upgrading to the latest firmware revision (typically to

match the software revision).

- Siren Time:

This is the duration for any siren

activations for the entire system/panel.

The Siren Feature: This pertains to monitored sensors

(input points), system/equipment conditions, and/or

panic/emergency keys that have been set to trigger a

siren condition—as signalled by a programmable

output set to activate on a system or area "siren"

condition.

Also see:

•

Equipment Settings (Pseudo / Internal Inputs)

•

Input Points—Monitored Sensors

Emergency keys: Pertains to 1st 3 inputs on an

LCD keypad.

•

Input Points—Pre-Defined Sensor Types

•

Input Points—Custom Point Types

•

Programmable Outputs (Signalling & Device-

Switching)

- AC Synchronization:

Frequency of AC source

to sync with for panel time display accuracy.

Note:

With an unstable AC service, select "No

Sync--AC Power Detection" (AC failure will be

reported if the frequency drops below 12.5 Hz);

- SNAPP Baud Rate:

This is the speed this main

panel communicates with the modules

connected to it.

The higher speed (38400) is recommended in all

systems (especially with door and/or elevator

controllers), and

required

with suite-security

keypads.

Note:

Trouble-free communications

requires proper (shielded) cabling, and adherence to

wiring guidelines covered in your system-

commissioning guide.

- System Message:

A greeting of up to 16

characters to appear at LCD displays (alternates

with the time, and alarm conditions).

- Input Point Fast Restore:

Whether or not a

point restoral (return to normal) is to be sent

within 1 minute (versus only at siren time-out);

- Ring Back Required on Arming:

Whether or

not the monitoring station will cause a keypad

tone and short siren squawk to confirm each

time an area is armed--as required for UL-listed

systems.

LCD Keypad Only

- Prompt for Entry Delay on LCD Keypad:

Whether or not the user will be asked if they

want the optional entry delay each time any area

is set to STAY. (An entry delay provides time

for an authorized entrant to disarm the area.)

-Arm/Disarm Local Area Only:

This limits a

system LCD keypad to allow arming and

disarming of only the area associated with the

keypad. (Otherwise, users can arm any area

as per their assigned authority).

Configuration System

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 323 324

Commentaires sur ces manuels

Pas de commentaire

Verex MONITOR AFx Guide de l'utilisateur Page 177

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Verex MONITOR AFx